Sabio SD-KN1 Assembly Manual
           | |
Contents
| 
Rev. 1.4Sabio Digital KN1 Assembly Guide 7 of 11 www.sabioproducts.comSection 6.0 - Memory Module InstallationThere are two memory expansion SODIMM slots on the SD-KN1 notebook, andthe notebook comes standard with no memory installed. The memory capacity isupgradeable up to 2GB using two 1025MB memory modules. To install a memorymodule follow these basic steps:1. Remove memory module cover (same as the CPU thermal module cover)on the bottom of the notebook using a small Phillips screwdriver.2. Notice that each memory module is keyed and can be only installedproperly by aligning the notches of the module with the guides in theSODIMM connector.3. Insert the memory module at a 45-degree angle into the connector andpress down until the module clicks into place. (Illustration 6)4. Replace memory module cover.Illustration 6 – Insert memory module at 45-degree angle |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine