Saeco 711547608 Operating Instructions Manual

• 27 •ENGLISHDISPENSING, CHECK THAT THE STEAMNOZZLE (PANNARELLO OR CAPPUCCINATORE)IS DIRECTED OVER THE DRIP TRAY.7 HOT WATER DISPENSINGDanger of scalding!Dispensing may be preceded by shortsprays of hot water. The dispensing nozzle canreach high temperatures: do not touch it withbare hands.• (Fig.4) - Turn on the machine, if not already on,with the main switch (2); the LED (3) lights up.• Wait until the machine ready LED (5) lights up.• (Fig.17) - Place a container or a tea glass underthe steam nozzle (pannarello).• Open the “hot water/steam” knob (7) by turning itanti-clockwise.• (Fig.18) - Press the coffee button (4) to dispensewater until the desired quantity is reached.• When the desired quantity of hot water has beendispensed, press the coffee button again (4).• (Fig.19) - Turn the knob (7) clockwise to close thetap.• Remove the container with hot water.8 STEAM DISPENSINGDanger of scalding!Dispensing may be preceded by short spraysof hot water. The brewing nozzle can reach hightemperatures: do not touch it with bare hands.• (Fig.4) - Turn on the machine, if not already on,with the main switch (2); the LED (3) lights up.• Wait until the machine ready LED (5) lights up.• (Fig.20) - Press the steam switch (6). The machineready LED (5) switches off.• Wait until the ready machine LED (5) lights upagain. The machine is now ready for steamdispensing.• (Fig.17) - Insert a container below the steamnozzle and open the “Hot water/steam” knob (7)for a few seconds, so that remaining water exitsfrom the steam nozzle (pannarello); in a shorttime only steam will come out.• (Fig.19) Close the knob (7) and remove thecontainer.• (Fig.21) - Immerse the steam nozzle in thedrink to be warmed and open the knob (7); turnthe container with slow upward movements sothat it is warmed evenly.• (Fig.22) - After using the steam for the desiredtime, close the knob (7); remove the containerwith the warmed beverage.• (Fig.20) - Press the steam switch again (6).• Proceed with circuit recharging as described inpar. 4.5 to make the machine ready for use.• (Fig.23) After this operation, clean the steamnozzle with a damp cloth.9 PREPARING CAPPUCCINODanger of scalding!When starting dispensing short sprays ofhot water may come out. The brewing nozzle canreach high temperatures: Do not touch it withbare hands.• (Fig.4) - Turn on the machine, if not already on,with the main switch (2); the LED (3) lights up.• Wait until the machine ready LED (5) lights up.• (Fig.20) - Press the steam switch (6). The machineready LED (5) switches off.• Wait until the ready machine LED (5) lights upagain. The machine is now ready for steamdispensing.• Turn the pannarello 90° clockwise and extract it.