Saeco Cafissimo Tuttocaffe Operating Instructions Manual

Contents

• 18 •Filter coffee or large cup : Drip tray inthe bottom position.Follow the instructions below to use your desired cup:Espresso cup or caffè crema cup :Drip tray in the top position.Latte macchiato glass: Completely removethe drip tray and place the glass directly onthe machine base underneath the drip tray.Espresso (white) = “black capsule”Caffè crema (yellow) = ‘’yellow capsule’’Filter coffee (blue) = “blue capsule”BREWING COFFEECoffee preparation1- Turn on the machine by pressing the ON/OFF button. Theflashing button shows that the machine is in the heating phase.Before brewing a coffee, check that the On/Off buttonand beverage buttons are constantly lit and thatthere is enough water in the tank.Never insert fingers or any other objects into thecapsule compartment. Single-portion capsules brewa single coffee. Do NOT use capsules more than once. Whenpreparing an espresso or caffè crema, the machine performsa pre-brewing cycle. There is an audible pause in the brewingprocess between the pre-brewing and brewing cycles.Fig. 1 Fig. 2 Fig. 3If the compartment does not close easily, check thatthe capsule is correctly inserted and that the usedcapsule drawer is not full.5- Press the (white) button for an espresso, the (yellow)button for a caffè crema or the (blue) button for a filtercoffee.6- The coffee brewing process stops automatically when the presetlevel is reached. However, you can stop dispensing earlier bypressing the same button another time.7- Lift the lever to eject the used capsule into the used capsuledrawer.8- Enjoy your freshly brewed coffee.With every coffee brewed, a small amount of excesswater is dispensed into the drip tray. Therefore,empty the drip tray regularly.If the machine stops during the brewing process andthe service indicator light slowly flashes orange,there is no more water in the water tank. Proceed as follows:Fill the tank with water and push the button of the drink thatwas being dispensed. As soon as the desired quantity has beenreached, stop dispensing by pressing the beverage buttonagain.We recommend emptying the used capsule drawerand waste water drawer daily. Before inserting acapsule, make sure that the used capsule drawer is not full.If the machine has not been used for a long time, orif the coffee cup is cold, we suggest placing the cupunderneath the spout and pressing the espresso buttonwithout using a capsule. The cup will be filled with hot water.This will heat the machine and the cup.After that, empty the cup and follow the steps below.1- Place a small or large cup underneath the coffee dispensingspout as indicated in the paragraph “Adjusting the dispensingheight”.2- Lift the capsule compartment opening lever (Fig. 1).3- Insert a capsule as illustrated (Fig. 2).4- Lower the lever to close the capsule compartment (Fig. 3).