Saeco IDEA Instruction And Maintenance

Also see for IDEA: Idea instruction and maintenance manual Manual

Contents

English16610.5 Serial port connectionThrough the serial port the machine can be connected to theAUTHORIZED CUSTOMER SERVICE CENTER’s equipment,for checks or programming operations (A - F. 10).The connection point (electric plug or all-pole switch)must be located in an easily reachable place, inorder to disconnect the machine from the electric linein case of need.• Connect the cord (G - F. 7) to the electric network.F. 10A10.4 Electric connectionNOTE - In case of plants with a 400 V two-phase current,use the two phases to supply the machine with230 V single phase current (F. 8). As for the 230V single-phase connection, require the specialinstallation kit (code %1034.R09).• Place the machine on the support and insert the electricpower cord (G - F. 7) in the hole (A).F. 8F. 9CEIL1L2N L2L1Neutral (N) ă BluePhase (L1 ) ă BrownPhase (L2 ) ă BlackGround ă Yellow/greenCH(Switzerland)Power cord type H07RNFsection 4x2,5 mm2Connection of the two phase electric line plug 400 V2N~Depending on the current regulations of the Countrywhere the machine operates, the cable connectingthe electric line has to be pre-set or equipped withan all-pole switch (with a minimum contact openingof 3 mm), (or with a plug in accordance with thesame regulations).• The all-pole switch has to be adequate to themachine power consumption and must be able tointercept every voltage polarity.• Check if the electric cables of the system are pro-portioned to the machine power consumption.Should the machine be moved to a different place, thefitting unit must be replaced with a new one (water networkconnecting pipe).The water mains pipe should be certified according to thestandard IEC 61770.