• 8 •Key to Machine Parts (Page 2)1 Control panel2 Water tank lid3 Hot water / steam knob4 Seat for accessories5 Water tank6 Cup holder surface7 Water recovery tray + grill (if any)8 Coffee brew unit9 Steam wand10 Power cord11 Pressurized fi lter holder12 Ground coffee measuring scoop13 Ground coffee fi lter(single piece for 1 or 2 coffee(s))14 ON/OFF button15 "Machine on" indicator lightLight ON = the machine is onLight OFF = the machine is off16 Coffee brew button17 Coffee/water - "Machine ready" indicator lightLight ON = OK for coffee brewing / hot water dispensingLight OFF = temperature is too low for coffee brewing /hot water dispensing18 Steam button19 "Steam ready" indicator lightLight ON = OK for steam dispensingLight OFF = temperature is too low for steam dispensing4 INSTALLATIONFor your own and other people safety, carefully followthe "Safety Regulations" indicated in chapter 3.4.1 PackagingThe original packaging has been designed and manufacturedto protect the machine during transport. We recommend keep-ing the packaging material for possible future transport.4.2 Installation PrecautionsBefore installing the machine, read the following safety pre-cautions carefully:• Place the machine in a safe place.• Make sure children cannot play with the machine.• Do not place the machine on hot surfaces or near openfl ames.The coffee machine is now ready to be connected to the electricnetwork.Note: We recommend washing the componentsbefore using them for the fi rst time and/or af-ter they have not been used for a certain period of time.4.3 Water Tank• (Fig.1A) - Remove the lid from the water tank (2) by liftingit.• (Fig.1B) - Remove the water tank (5).Note: The machine accessories are placed onthe water tank's (5) side.• (Fig.2) - Rinse the water tank and fill it with fresh drink-ing water: do not exceed the (MAX) level indicated on thewater tank.Fill the tank only with fresh, non-sparkling,drinking water. Hot water or any other liquidmay damage the tank. Do not operate the machinewithout water: make sure that there is enough water inthe tank.• (Fig.3) - Insert the water tank making sure that it hasbeen properly repositioned in its former seat and thenreposition the lid (2).Make sure that the tank is fully inserted in themachine by pressing it gently up to its limit stop(THE REFERENCE MARK SHOWN IN FIG.4 MUST BE COM-PLETELY VISIBLE). This is to avoid water leaks from itsbottom.4.4 Machine ConnectionElectric power may be very dangerous! It istherefore necessary to strictly follow the safetyregulations. Do not use faulty power cords! Faulty cordsand plugs must be replaced immediately by AuthorisedService Centres.The voltage of the appliance has been pre-set by the manu-facturer. Check that the voltage matches the indication on theidentifying data plate at the bottom of the appliance.• Insert the plug into a wall socket with suitable power volt-age.