Saeco TALEA Service Manual

Saeco TALEA Service Manual Manual pdf 26 page image

Page 13 / 13 Saeco International Group03 OPERATING TALEA / ODEA - LINEDISPLAY MESSAGE SHOWN INSTRUCTIONS FOR TROUBLESHOOTINGTurn machine off and on to solve the problem Turn the appliance off and then back on after 30seconds to resolve the fault.Call Service Centre The problem requires the intervention of the ServiceCentreInsert drip tray Insert the drip trayClose coffee bean hopper lid The coffee bean hopper lid must be closed toproduce beverages.Insert ground coffee This message is shown if the user selected the use ofthis type of coffee when the products were specificallyprogrammed.Insert brewing unit Insert the brewing unit in its intended locationInsert dreg drawer Insert the dreg drawerEmpty dreg drawer Remove the dreg drawer and empty.NOTE: the dreg drawer must only be emptied whenthe appliance is switched on. The drawer mustbe removed for at least 5 seconds. If the draweris emptied when the appliance is switched off themessage is not reset.Close side door Close the service door.Fill water tank Fill the water tankEmpty residual water tray Empty residual water trayPrime circuit Start the automatic water cycle filling The appliancemakes 5 attempts to fill the cycle automatically.If these attempts fail, the Service Centre must beinformed about these ventilation attempts.The descaling cycle did not run correctly. Repeat the operation as described in the appropriatechapter in the instruction bookletReplace Aqua Prima filter This message is only displayed if the filter control isenabled (see notes in the instruction booklet)The filter should be replaced in the following cases:1) Over 60 litres of water have been dispensed fordrinks2) 90 days have elapsed since installation3) 20 days have elapsed since the coffee maker waslast used.The cleaning cycle did not run correctly Repeat the operation as described in the relevantchapter in the instruction booklet.Descale appliance Carry out the descaling cycleStandby Press the “ON” key3.3 Messages - troubleshooting