41 42UAS Installation1. Remove UAS fromStorage LocationOr if UAS was used rearfacing, pull UAS belt out ofrear-facing belt path so bothhooks are on the same sideof the seat.WARNINGS: Do not use the vehicle lap or lap/shoulderbelt when using the Universal Anchorage System (UAS).Check UAS belt before each use. Use only if the belt can betightened properly and securely.Do not fasten both UAS hooks on the same UAS anchor barin the vehicle.Do not use any recline position except to install the childrestraint fl ush against the vehicle seat back. Vehicle seatback must be upright.Failure to follow these warnings can result in serious injuryor death.Review your vehicle owner’s manual for UAS belt use.continued on next pageSafety TipsMake sure harness and buckle fit your child correctly beforeinstalling the child restraint. See pages 3-4.Experts agree that children should remain rear facing as long aspossible. In this child restraint, your child can remain rear facing upto 18 kg (40 lb) and up to 91 cm (36 in.).2. Route UAS HookThrough Forward FacingBelt PathThe UAS adjuster can be on eitherside.Do not twist belt.4. Place Child RestraintForward Facing FlushAgainst Vehicle SeatBackDo not use any recline positionsexcept to make the child restraintflush against the vehicle seat back.Vehicle seat back must be upright.3. Finished UAS Routing5. Loosely Attach TetherHookCheck vehicle owner’s manual forspecific location.