2 SAGEM SA document. Reproduction and disclosure forbidden. SK-0000011322-02ESSAFETY INSTRUCTIONSThe installation of this product should be made by a qualifiedservice Person and should conform to all local codes.It is strongly recommended to use a class II power supply at 12 V±5% and 2.5 A/min according with Safety Electrical Low Voltage(SELV). The 12 V power supply cable length should not exceed3 meters.This product is intended to be installed in accordance with theNEC Class 2 requirements; or supplied by a listed external PowerUnit marked Class 2, Limited Power source, or LPS and rated 12 VDC, 2.5 A minimum.In case of building to building connection it is recommended toconnect 0 V to ground. Ground cable must be connected with theterminal block board fixation screw marked with universal groundsymbol.Europe: SAGEM SA hereby declares that the SAGEM SAMorphoAccess™ has been tested and found compliant with thebelow listed standards as required by the EMC Directive 89/336/EEC: EN55022 (1994)/EN55024 (1998) and by the low voltageDirective 73/23/EEC amended by 93/68/EEC: EN60950 (2000).USA: This equipment has been tested and found compliant withClass B digital device requirements, pursuant to part 15 of theFCC Rules. These requirements are designed to ensurereasonable protection against harmful RF interference in aresidential installation.This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with theinstructions, may interfere with radio communications. If thisequipment interferes with radio or television reception - which canbe determined by disconnecting and re-connecting the unit - theuser is encouraged to try to correct the interference by one or moreof the following measures:− Reorient or relocate the receiving antenna.− Increase the separation between the equipment and receiver.− Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.− Consult the dealer or an experienced radio/TV technician forhelp.