Samsung 2.0041112184342e16 Instruction Manual

GBGBFM antenna connection1. Connect the FM antenna supplied to the FM 75ΩCOAXIAL terminal.2. Slowly move the antenna wire around until youfind a location where reception is good, thenfasten it to a wall or other rigid surface.• If reception is poor, connect an outdoor antenna.Before attaching a 75Ω coaxial cable (with a standardtype connector), disconnect the supplied FM antenna.AM/MW antenna connection1. Connect the AM loop antenna suppliedto the AM and terminals.2. If reception is poor, connect an outdoorsingle vinyl-covered wire to the AMterminal. (Keep the AM loop antennaconnected).12Connecting the FM and AM(MW/LW) Antennas11A cooling fan is mounted on the rear panel of the center unit toprevent abnormal temperature inside the center unit, thus assuringnormal operation. The cooling fan automatically starts rotating tosupply external cool air to the inside of the center unit when theinternal temperature exceeds the specified limit.For safety, observe the following carefully.• Make sure there is good ventilation around the center unit. Poorventilation could overheat and damage the canter unit.• DO NOT block the cooling fan and the ventilation openings orholes. (If they are blocked by a newspaper or cloth, etc., the heatmay not be able to escape.)(About the cooling fan)AUX ConnectionsSnap the tabs on the loop into theslots of the base to assemble theAM loop antenna.Cooling fan (See “About Cooling Fan” below.)VIDEO ANTENN AS-VIDEOANTENNA1 2 3If FM reception is poor,connect outdoor FM antenna(not supplied).FM Antenna (supplied)AM Loop Antenna(supplied)If AM reception ispoor, connect anoutdoor AMantenna(notsupplied).VIDEO ANTENN AS-VIDEOVIDEO INTVExternal AnalogComponentsAudio Cable (Red/White)To view pictures from theexternal input (AUX),first connect the VIDEOIN jack (VIDEO) and thenconnect the VIDEO OUTjack.Connect to external equipment withanalog outputs.Example: Video, TV, etc.• Always connect the video andaudio connection cables to theequivalent colored jack.Press the AUX button and select AUX IN.Making Analog Input SelectionPress the Function button and select AUX IN.Remote ControlMain UnitIf the external analogcomponent has only oneoutput jack, you mayconnect either L or R.