Samsung 4 Series User Manual
Also see for Series 4+: User manualUser manualUser manualUser manualUser manual
                                                                                     | |
Contents
|
Using the D FunctionYou can enjoy D movies and games on your TV. The D effects function enables you to view D images using special Dglasses.Connections❑1. Connect a HDMI/DVI cable between the HDMI IN 2 jack on the TV and the PC output jack on your computer.. Connect a 3.5mm Stereo plug to 2RCA cable between the DVI IN (HDMI 2) [R-AUDIO-L] jack on the TV and the Audio Out jack ofthe sound card on your computer.. Connect the Emitter to the 3D SYNC OUT port on the rear panel of the TV.4. Turn the TV on and set the source of the TV to HDMI2/DVI.For more information on the 3D glasses (including the Emitter), refer to the user manual of your 3D glasses.Adjust the PC resolution: - PL42B450B1: 1024 x 768@60Hz- PL50B450B1: 1024 x 768@60Hz,1360 x 768@60HzOptimum PC resolution for PL50B450B1 is 1360x768. When 1024x768 signal is connected in 3D mode, the picture will be shown in4:3 format with left and right side grey bars appeared.The 3D IR Emitter communicates with the 3D glasses.Therefore, the 3D IR Emitter should be located near the 3D glasses.It is activated when the HDMI or DVI input signal is RGB, and DVI Sound is supported.When the power is turned on or off, the mode changes to the default (Off) and the Format is saved.To use the 3D Effect function, a graphics card supporting 3D or 3D software is required.The 3D glasses and the Emitter must be manufacturer by the same company.If you play a game or watch TV while wearing the 3D glasses for long periods of time, you may experience eyestrain or a headache.3D glasses (including the Emitter) not manufactured by Samsung may not be supported.If you find the screen flickering while the 3D function is used, change the environmental lighting darker or turn off the fluorescentlamp to watch the screen for its best condition.NNNNNNNNNNNThe appearance of the 3D glasses (including Emitter) may differ depending on the model of your glasses.NContinued...Scrolling: This function removes after-images on the screen by moving all the pixels on the PDP according to a pattern. Usethis function when there are remaining after-images or symbols on the screen, especially when you displayed a still image onthe screen for a long time.Side Gray: When you watch TV with the screen ratio of 4:3, the screen is prevented from any damage by adjusting the whitebalance on both extreme left and right sides. To prevent the screen burn from happening, select Dark or Light.- Dark: When you set the screen ratio to 4:3, it darkens the left and right sides.- Light: When you set the screen ratio to 4:3, it brightens the left and right sides.To remove after-images on the screen, use the Scrolling function.The after-image removal function has to be executed for a long time (approximately 1 hour) to effectively remove after-imageson the screen. If the after-image is not removed after performing the function, repeat the function again.Press any key on the remote control to cancel this feature.••NNNEnglish - 4D Glasses(Not supplied)D IR Emitter(Not supplied)PCTV Rear Panel.5 mm Stereo plug to RCA Cable (Not supplied)HDMI/DVI Cable (Not supplied)1 |
Related manuals for Samsung Series 4+
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine