English - 26TV Remote Control Buttons Available in Anynet+ ModeDevice Type Operating Status Available ButtonsAnynet+ DeviceAfter switching to the device, when themenu of the corresponding device isdisplayed on the screen.Numeric buttons▲/▼/◄/►/ENTERE buttonsColour buttons / EXIT buttonAfter switching to the device, while playinga fileπ(Backward search) / μ(Forward search) / ∫(Stop) /∂(Play) / ∑(Pause)Device with built-in TunerAfter switching to the device, when youare watching a TV programme P > / P < buttonAudio Device When Receiver is activated Volume / MUTE buttonThe Anynet+ function only works when the active source on the TV remote control is set to TV.The ∏ button works only while in the recordable state.You cannot control Anynet+ devices using the buttons on the TV. You can control Anynet+ devices only using the TV remotecontrol.The TV remote control may not work under certain conditions. If this occurs, reselect the Anynet+ device.The Anynet+ functions do not operate with other manufacturers’ products.The π, μ operations may differ depending on the device.RecordingYou can make a recording of a TV programme using a Samsung recorder.1. Press the TOOLS button. Press the ENTERE button to select Anynet+ (HDMI-CEC).2. Press the ▲ or ▼ button to select Record: (device_name), then press the ENTEREbutton. Recording begins.When there is more than one recording deviceWhen multiple recording devices are connected, the recording devices are listed.Press the ▲ or ▼ button to select a recording device and press the ENTEREbutton. Recording begins.When the recording device is not displayedSelect Device List and press the red button to search devices.3. Press the EXIT button to exit.You can record the source streams by selecting Record: (device_name).Pressing the ∫ button will record whatever you are currently watching. If you are watching video from another device, thevideo from the device is recorded.Before recording, check whether the antenna jack is properly connected to the recording device. To properly connect anantenna to a recording device, refer to the recording device’s users manual.Listening through a Receiver (Home Theatre)You can listen to sound through a receiver instead of the TV speaker.1. Press the TOOLS button. Press the ENTERE button to select Anynet+ (HDMI-CEC).2. Press the ▲ or ▼ button to select Receiver. Press the ◄ or ► button to select On or Off.3. Press the EXIT button to exit.If your receiver supports audio only, it may not appear in the device list.The receiver will work when you have properly connected the optical in jack of the receiver to theDIGITAL AUDIO OUT (OPTICAL) jack of the TV.When the Home Theatre receiver is set to On, you can hear sound output from the TV’s Optical jack. When the TV isdisplaying a DTV(air) signal, the TV will send out 5.1 channel sound to the Home theatre receiver. When the source is a digitalcomponent such as a DVD and is connected to the TV via HDMI, only 2 channel sound will be heard from the Home Theatrereceiver.If there is a power interruption to the TV when the Receiver is set to On (by disconnecting the power cord or a power failure),the Speaker Select may be set to External Speaker when you turn the TV on again. (see page 18)NNNNNN¦NNNNN¦NNNNView TVDevice ListRecord : DVDRDVDR MENUDVDR OperationReceiver : OnSetupU Move E Enter R Return
