Samsung 7 SERIES User Manual

Also see for 7 Series: User manual User manual User manual User manual User manual

Contents

English - 16− Brightness Test: This test checks to see if your room is brightenough for Motion control to work properly. Select Startusing your remote. The test will start and should take only afew seconds.− Camera Angle Test: Start Camera Angle Test Select Startusing your remote. Please put yourself in the rectangle onthe screen by adjusting the camera or moving around. If youare not located in the correct position, the test may not workproperly. When done, please spread your hand in the directionof the camera, and shake it three or four times from a sideto side.To use the Motion control function, follow these steps:1. To use the Motion control, raise your hand while opening it towardthe screen, hold it for a moment and then wave it 3 – 4 time to theleft and right. Motion control starts. If the Motion control starts,the cursor is displayed at the center of the screen and the Motionguide bar size is at the bottom of the screen.2. Control the TV using your hands.✎ Note that the Motion control function closes if your hands go outof the camera range.✎ While using the Motion control, if you use the other device (i.e.remote control, keyboard, etc.), Motion control closes.Controlling the TV with your hands using Motions■ Access Motion Control− Action: Spread your hand in the direction of the camera, andshake it three or four times from a side to side.■ Pointing NavigationMoves the cursor to the position you want.− Action: Spread your hand and guide the cursor to positionyou want.■ RunSelects an item or executes a command that is indicated by thecursor or is highlighted.− Action: Clench your fist.BackReturn to the previous menu.− Action: Spread your hand and rotate it counter clockwise.■ Channel / Volume ControlChanges the channel or adjust the volume.✎ If you use the Motion control function while watching achannel, the channel / volume control screen appears.− Action: Use the Pointing Navigation gesture to move thecursor to the channel or volume controller, and then uses theRun gesture to adjust the channel or volume.✎ If you use the Run gesture once, it has the same effectas pressing a button on your remote. If you hold theRun gesture, it has the same effect as pressing andholding a button on your remote.■ ScrollScroll the page in the direction you want. For example, supposethat you want to scroll down.✎ Some applications may not support this function.1. Move the cursor to the bottom of the screen (page scroll zone)using the Pointing Navigation gesture.2. Move the cursor to the centre of the screen using thePointing Navigation gesture.3. The page will move down.Face recognition™ → Tools → Settings → Account Manager → Change accountinformation → Register faceEnable or disable the Face recognition function. Lets you register yourface in your Samsung account. Also, you can log in to the Samsungaccount using the Face recognition function without inputting youraccount ID or your account password.✎ You can register your face in only one account.To register your face in your Samsung account, follow these steps:✎ To use this function, you must log into Smart Hub. If you don'thave a Samsung account, you should create one before usingthis function. To create your Samsung account, refer to “Creatingan Account” (Advanced Features → Smart Hub) in the e-Manual.1. On the Smart Hub screen, open the Tools menu using yourremote, and then select Settings.2. Select Account Manager. The Account Manager screen appears.3. Select Change account information. The Change accountinformation screen appears.4. Select Register face. If you agree to use facial recognition, selectOK.5. Enter your account password.6. Move your face into the facial lines at the centre of the screen, andthen wait until the facial lines changes from red to green.✎ If Face recognition fails, select Retry and try again.7. When finished, your face is now registered in your Samsungaccount.To log in to your Samsung account using Face recognition, followthese steps:If you use Face recognition to log into Smart Hub, it may be lesssecure than logging in with a password.1. With the Smart Hub screen displayed, select a using yourremote. The ID/password screen appears.2. Select Face Recognition Mode. The Face recognition screenappears.✎ To return to the ID/password screen, select Passwordmode.3. The TV starts Face recognition. Face the front of the TV screen.The TV will recognize your face automatically.✎ If the TV fails to recognize your face, try again.4. The TV logs you into your Samsung account automatically.✎ If the TV recognizes two or more registered faces, theSamsung account list appears. Select your account to log in.✎ If your face is unregistered, you can register your face inyour Samsung account. Follow steps 4 through 5 in the “Toregister your face to your Samsung account” procedureabove.✎ If you have no account, you can create one. For moredetailed information, refer to “Creating an Account”(Advanced Features → Smart Hub) in the e-Manual.