Samsung 7000 User Manual

Also see for OfficeServ 7000 Series: System administration guide User guide User instruction User guide User guide

44 EnglishAdvanced FeaturesAnynet+ MenuThe Anynet+ menu changes depending on the type and status of the Anynet+ devices connected to the TV.Anynet+ Menu DescriptionView TV Changes Anynet+ mode to TV broadcast mode.Device List Shows the Anynet+ device list.(device_name) MENU Shows the connected device menus. E.g. If a DVD recorder is connected, the disc menu ofthe DVD recorder will appear.(device_name) INFO Shows the play menu of the connected device. E.g. If a DVD recorder is connected, theplay menu of the DVD recorder will appear.Recording: (*recorder) Starts recording immediately using the recorder. (This is only available for devices thatsupport the recording function.)Stop Recording: (*recorder) Stops recording.Receiver Sound is played through the receiver.If more than one recording device is connected, they are displayed as (*recorder) and if only one recording device isconnected, it will be represented as (*device_name).¦ Setting Up Anynet+O MENUm Application Anynet+ (HDMI-CEC) ENTERE■ SetupAnynet+ (HDMI-CEC) (Off / On): To use the Anynet+ Function, Anynet+ (HDMI-CEC) must be set to On.✎ When the Anynet+ (HDMI-CEC) function is disabled, all the Anynet+ related operations are deactivated.Auto Turn Off (No / Yes): Setting an Anynet+ Device to turn off automatically when the TV is turned off.✎ The active source on the TV must be set to TV to use the Anynet+ function.✎ Even if an external device is still recording, it may turn off.¦ Switching between Anynet+ Devices1. Anynet+ devices connected to the TV are listed.✎ If you cannot find a device you want, press the Red button to refresh the list.2. Select a device and press the ENTERE button. You can switch to the selected device.✎ The Device List menu will only appear when you set Anynet+ (HDMI-CEC) to On in the Application menu. Switching to the selected device may take up to 2 minutes. You cannot cancel the operation during the switchingoperation. If you have selected external input mode by pressing the SOURCE button, you cannot use the Anynet+ function.Make sure to switch to an Anynet+ device by using the Device List.