Samsung ACH2400C Owner's Instructions & Installation Manual

Also see for ACH2400C: Service manual Owner's instructions & installation manual

Contents

Heating Your RoomE-15ENGLISHAutomatic(rotated : ➔ ➔ )LowMediumHighYou must select the HEAT mode if you wish to adjust the : Heating temperature Fan speed when heating1To select the HEAT mode, press the Mode button until is displayedat the top of the wired remote controller.Result: The air conditioner runs in HEAT mode.2The air conditioner is fitted with a protection mechanism toprevent the unit from being damaged when it is startedimmediately after being: Plugged in Stoppedlt will start up normally after three minutes.You can change modes at any time.If necessary, press (ON/OFF) button.Result: The On/Off indicator on the wired remote controller comes on. The air conditioner runs in the mode selected when the unit was last used.IMPORTANTNNNN oooo tttt eeeeTo adjust the temperature, press the Temperature buttons one or more timesuntil the required temperature is displayed. Possible temperatures are between61OF and 86OF inclusive.Result: Each time you press Temperature buttons:- The temperature is adjusted by 1OF. The air conditioner starts heating, provided that the room temperature is lower than the selected temperature ; the fan will, however, operate.3Select the fan speed by pressing the Fan button one or more times untilthe intended value is displayed :4To control the direction of the air flow, refer to page 17.5