installing your air conditioner _57ENGLISHChanging a particular optionOption SEG1 SEG2 SEG3 SEG4 SEG5 SEG6Explanation PAGE MODE The option modeyou want to changeThe tens’ digit of anoption SEG you willchangeThe unit digit of anoption SEG you willchangeChanged valueRemoteControllerDisplayIndicationand DetailsIndication Details Indication Details Indication Details Indication Details Indication Details Indication Details0 D Optionmode 1~6 Tens’ digitof SEG 0~9 Unit digit ofSEG 0~9Thechangedvalue0~FYou can change each digit of set option.Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6Explanation PAGE MODE The option modeyou want to changeThe tens’ digit of anoption SEG you willchangeThe unit digit of anoption SEG you willchangeChanged valueIndication 0 D 2 1 7 1• When changing a digit of an indoor unit address setting option, set the SEG3 as ‘A’.• When changing a digit of indoor unit installation option, set the SEG3 as ‘2’.Ex) When setting the ‘buzzer control’ into disuse status.NoteSEG 3, 4, 5, 6, 8, 9 additional informationWhen the SEG 3 is set as "1" and follow Auto Change Over for HR only operation, it will operate as follows.Cooling/Heating mode can be changed when Thermo Off status is maintained during the time with SEG9.A : Set with SEG4(˚C)B : Set with SEG5(˚C)C : Set with SEG6(˚C)D : Set with SEG8(˚C)Cooling Thermo OffHeating Thermo OffCooling Thermo OnHeating Thermo OnB CDTsAcaTemp.dbStandard temp.for HeatingStandard temp.for CoolingStandard temp. forHeating → CoolingStandard temp.for Cooling →HeatingSet temp.for Auto mode