Samsung AP-3607BR Owner's Instructions & Installation Manual

E-29Less than 15m(49ft)Less than 15m(49ft)1. Open the inlet grille, and remove the flare nut.2. Bend the connection pipe to an appropriate length using the spring bender dependingupon the installation place.- Allowable pipe length : Maximum 25m (82ft)- Allowable pipe drop distance : Maximum 15m (49ft)- Make no more than ten bending points on the pipeWhen the pipe length is in excess of the standard pipe length of 5m (16ft 5in), add the refrigerant(R-22) of 40g for each additional 1m.3. Install the high pressure pipe to the heat exchanger liquid pipe, and the low pressure pipe to theheat exchanger gas pipe respectively using the flare nut, taking care not to cause any leakage of refrigerant.4. Be sure to insulate the pipe with appropriate insulation material.5. Insert the drain hose into the drain pipe, and connect them by tying them to the cable tie to preventany water leakage.6. After completion of the installation, check the connecting area for any gas leakage.7. Wind a finish tape when the wiring of the refrigerant pipe, the unit, and the drain piping are completed.Indoor unitchecking areaOutdoor unitchecking areaCautionIf the pipe is lengthened, the performance of the unit is degraded, and the service life is shortened.Therefore, the pipe length should be as short as possible (less then 15m/49ft).Installation ProceduresINSTALLATION METHOD