Samsung AQ24P6GEA6/SAR Owner's Instructions Manual

Heating Your RoomE-11ENGLISHYou must select the Heat mode if you wish to adjust the:◆ Heating temperature◆ Fan speed when heating1 If necessary, press the (On/Off) button.Result: ◆ The operation indicator on the indoor unit lights up.◆ The air conditioner starts up in the mode selected whenthe unit was last used.◆ The indoor unit beeps.The air conditioner is fitted with a protection mechanismto prevent the unit from being damaged when it is startedimmediately after being:◆ Plugged in◆ StoppedIt will start up normally after three minutes.2 If the is not displayed at the top of the remote control, press thebutton on the remote control one or more times until it appears.Result: ◆ The indoor unit beeps each time you press the button.◆ The air conditioner runs in HEAT mode.NNNN oooo tttt eeee You can change modes at any time.3 To adjust the temperature, press the button one or more timesuntil the required temperature is displayed.Possible temperatures are between 16°C and 30°C inclusive.Result: ◆ Each time you press the button:- The temperature is adjusted by 1°C- The indoor unit beeps◆ The air conditioner starts heating, provided that the roomtemperature is lower than the desired temperature(selected temperature+3°C).◆ If the room temperature reaches the set temperature, the airconditioner stops heating, but the fan is still operating.4 Select the fan speed by pressing the button one or more timesuntil the required setting is displayed:Automatic (rotated : )LowMediumHighResult: ◆ Each time you press the button, the indoor unit beeps.◆ For the first three to five minutes, the fan operates veryslowly until the air has been sufficiently warmed. Once thecorrect temperature has been reached, the fan is automaticallyset to the required speed.5 To control the direction of the air flow, refer to page 17.IMPORTANT