E-12To get the best possible use out of your air conditioner, you must cleanit regularly to remove the dust that accumulates on the air filter.Before cleaning your air conditioner, ensure that you haveswitched off the electric circuit breaker used for the unit.Open the front grille by pushing on both sides and center.1Remove the front grille.2-1 Remove the safety clips.2-2 Open the front grille about 45° and pull it forward.2Pull out the air filters.3Remove all dust on air filters with a vacuum cleaner or a brush. In case ofserious dust accumulation, put the air filter in warm detergent water andshake it vertically.4Dry the air filter.5When you have finished, insert the air filters into the front grille.6Clean the unit with a vacuum cleaner or a brush once a month.7Reinstall the front grille and the safety clips.8IMPORTANTYou must give attention when disassembling the front grilleand must check the safety clips have been installed.If you do not check them, the front grille will drop suddenlyand you will be hurt.IMPORTANT After cleaning the air conditioner, press the Filter Reset button.NNNN oooo tttt eeeeWhen you have installed the Bio-Pure filter, do not allow anyliquids to contact the filter. It may lose its properties.NNNN oooo tttt eeeeYou can use all 2 points of the indoor unit for installing the frontgrille and the safety clips depending on your requirement.NNNN oooo tttt eeeeCleaning Your Air ConditionerSafety ClipWired Remote Controller Wireless Remote Controller