E-15Solving Common ProblemsExplanation / Solution Check that the circuit breaker used for the air conditioner has not beentriggered. Check that the power cable is plugged into a wall socket and the socket isswitched on, if necessary. Check that the temperature indicator on the unit is lit; if necessary,press the (On/Off) button on the remote control or unit. Check that there are no obstacles between you and the unit. Replace the remote control batteries if necessary. Check that you are close enough to the unit (seven metres/yards or less). Ventilate the room.ProblemThe air conditioner doesnot operate at allThe air conditioner does notoperate with the remotecontrolOdors are permeating theroom during air conditioning Check that you are pointing the remote control at the remote control sensoron the unit. Replace the remote control batteries if necessary.No beep is heard when youpress the (On/Off) buttonon the remote control Check that the correct operating mode has been selected(Cool). The room temperature may be too low. Dust may be blocking the air filter; refer to page 16 for cleaning instructions. Check that there is no obstacle blocking the air flow into or out of the unit.The air conditioner does notcool Check that the timer has been programmed correctly; refer to page 10~12.The timer is not correctlytriggeredBefore contacting an authorized service center, perform the following simple checks.They may save you the time and expense of an unnecessary call.Technical SpecificationsModel Power SupplyAW05MDYEADesign and specifications are subject to change without notice.220-240V~, 50Hz➢ Max current is measured according to IEC standard for safety andcurrent is measured according to ISO standard for energy efficiency.This condition belongs to the above model.