11If you wish to listen a programme or recording using DolbySurround, you can connect additional speakers.The four speaker terminals are located on the rear of the television: Two for the left-hand speaker (marked L) Two for the right-hand speaker (marked R) Two for the centre speaker (marked C); OptionTo improve the quality of the sound, connect the: Red wire to the red terminal Black wire to the black terminal1 To connect a wire to a terminal, push the tab back as far as it willgo.2 Insert the wire, up to the plastic sheathing, in the hole.3 Release the tab.Result: The wire is pinched and held firmly in place.4 Repeat the operation for each wire.5 Connect the other end of the wires to the loudspeakers.You must insert or replace the batteries in the remote control whenyou: Purchase the television Find that the remote control is no longer operatingcorrectly1 Remove the cover on the rear of the remote control by pressingthe symbol downwards and then pulling firmly to remove it.2 Insert two R03, UM4, “AAA” 1.5V or equivalent batteries takingcare to respect the polarities: + on the battery against + on the remote control - on the battery against - on the remote control3 Replace the cover by aligning it with the base of the remotecontrol and pressing it back into place.➢ Do not mix battery types, i.e. alkaline and monganese.ENGInserting the Batteries in the Remote ControlConnecting Additional SpeakersREAR SPEAKER (16Ω)R LAUDIO OUTL R CCENTER SPEAKER (8Ω)OPTIONRear of the TV