12ENGPlug & Play Feature (depending on the model)When the television is initially powered ON, three basic customersettings proceed automatically and subsequently: setting thelanguage, channel and clock.1 If the television is in Standby mode, press the POWER ( ) buttonon the remote control.Result: The message Plug & Play is displayed. It flickers for alittle while and then the “Language” menu is automaticallydisplayed.2 Press the ▲ or ▼ button to select required language. Press theMENU button to enter the language, and then the message Ant.Input : Check is displayed.➣ If any language is not selected on the Language menu, the“Language” menu will be displayed about 30 seconds later.3 Make sure that the antenna is connected to the TV. And then pressthe œ or √ button to store the channels (refer to “Storing theChannels Automatically” on page 14).Result: The horizontal bar is displayed, and then channels arestored in an order which reflects their positions in thefrequency range.4 When searching and storing is complete, the Time menu isdisplayed.5 Press the œ or √ button to move to the hour or minute. Set thehour or minute by pressing the ▲ or ▼ button (refer to “Setting andDisplaying the Current Time” on page 30).6 When you have finished, press the MENU ( ) button.Result: The message ENJOY YOUR WATCHING is displayed, andthen the channel which has been stored will beactivated.7 If you want to reset this feature...1 Press the MENU button.2 Press the ▲ or ▼ button to select the Function, and thenpress the œ or √ button.3 Select the Plug & Play by pressing the ▲ or ▼ button, andthen press the œ or √ button.Result: The message Plug & Play is displayed.FunctionLanguage : EnglishTime √Plug & Play √Blue Screen : OffChild Lock √Demonstration √Plug & PlayENJOY YOUR WATCHINGAnt. Input CheckTimeClock 11 : 35P 1 C - - - - -471 MHz 48 %LanguageEnglish PortuguêsDeusch ItalianoFrançais SverigeNederland TürkçeEspanõl EÏÏËÓÈο