Samsung DA68-01453B Owner's Manual And Installation Instructions

30INSTALLING THE WATER DISPENSER LINE- Remove the compressor cover of the refrigerator.- Connect the water line to the valve, as shown in the figure.- When connected, check if there is any leakage.If any, repeat the connection.- Reattach the compressor cover of the refrigerator.- Using clip ”A”, fix the water line to the wall (the back of refrigerator).- When the water line is secure, make sure whether thewater line is not excessively bent, pinched or squashed.Complete the installation of the water supply line.- Power on the refrigerator and press the lever on the right of thedispenser until water runs out through the water line and all air has been empty.- At this time, check for any possible leakages at the join point in the water line.After securing the water line, move the refrigerator to the required location.Once the refrigerator is in position, do not move possibly.- As shown, separate the fixed cap in the refrigerator by rotatingit counterclockwise.Remove the water filter from the box and put a month indicatorsticker on the filter as shown.- Write the month you installed the filter on the label.EX) If the water filter was installed in March, put “MAR”- Remove the protective cap then position and insert the filter as shown,- Slowly turn the water filter clockwise 90º to align the indication mark on thecover, locking the filter in postion. Do not overtighten.Please check if the indication line aligns with the lock position.CLIP AWATER LINESTICKER(MONTH INDICATION)SEPARATIONOF RED CAPALIGN THE INDICATION MARKWITH LOCK POSITION.COVER FILTERWATER LINE CONNECTION NUTConnect the water line to the refrigerator.Secure the water line.Install the water filter.CAUTIONCOMPRESSOR COVER OFREFRIGERATOR