14_ setting upsetting up your side-by-side refrigeratorSETTING UP THE REFRIGERATOR(CONT’D)If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.Tools you will needRemoving the Front Leg CoverFirst, open both the freezer and refrigerator doors, and then take off the front leg cover by turning thethree screws counter-clockwise.Separating the Water Supply Line from the Refrigerator1. Remove two water lines(gray one is for ice and the other one is for water)by pressing the coupler1 and pulling the water line 2 away.Reattaching the Water Supply Line1. The Water Line must be fully inserted to themarked line to prevent water leakage fromthe dispenser.2. Insert the 2 clips in the install packand check that each clip holds theline firmly. These clips are for doorre-installation only.The water line must be fully inserted to the marked line to prevent water leakage from thedispenser.FRONT LEG COVERSCREW12Make sure the color of thewater lines match.Line LineCoupler Couplerclip A(¼”)(6.35mm)clip A(¼”)(6.35mm)Coupler CouplerPhilips Screwdriver Flat-blade Screwdriver 10mm Socket Wrench