Samsung DSB-4700F Instructions For Use Manual

Contents

5DSB-4700F4 D I G I T A L S A T E L L I T E R E C E I V E RCAUTIONYou are cautioned that any changes or modifications not expressly approved in this manualcould void your authority to operate this equipment.NOTE:This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.- Consult the dealer or an experienced radio/TV technician for help.oor Antenna Groundingre the antenna is properly grounded to provide some protection against voltages and built-up static charges.Example of Antenna Grounding as per National Electrical Codeto CATV System Installereminder is provided to call the CATV system installer’s attention to Article 820-40 of thethat provides guidelines for proper grounding and, in particular, specifies that the cabled shall be connected to the grounding system of the building, as close to the point ofentry as practical.: NEC 810-21 ( i )ding jumper not smaller than No. 6 AWG copper or equivalent shall be connectedeen radio and television equipment grounding electrode and the power groundingode system at the building or structure served where separate electrodes are used.25A_Eng 4/19/04 5:11 PM Page 4