Samsung DSB-S305G Instructions For Use Manual

GB-19DSB-S305G GBGB-18 D I G I T A L S A T E L L I T E R E C E I V E RInstallationmenu provides settings for customizing, adding newvices and displaying the status of the receiver.elect “Installation” in the main menu mode to select theub menu.nter the PIN Code.u have not entered your own PIN Code then theCode 0000 applies, which was set at the factory.LNB Settingcan select the satellite and LNB setting conditionsxecute channel search and you can alter the settings22KHz tone. The parameters set in this menu areded for programming the channels for the “Selectivenning” and “Network scanning”.necessary information can be found at your antennaLNB brochures, or you can ask your dealer.elect LNB power supply “On”.elect the desired satellite name.elect the LNB type (frequency).elect the DiSEqC ModeOff, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)Hz: In case you are using a dual LNB or two antennas connected to a 22KHz toneswitch box, with the 22 KHz tone switch (“On”, “Off” or “Auto”) you can switchbetween both LNB or antennas.Network Scanningsub menu “Network Scanning” will enable scan thennels from the LNB setting.hen you select “Network Scanning” menu, STB willearch all available channels from Cyfrowy Polsat NIT only.ress OK key to save found programs.OPERATING THE RECEIVER OPERATING THE RECEIVER2.3 Transponder ScanningIf you have a DiSEqC 1.2 motorized system which is fullycompatible with DiSEqC1.2, then you can take advantage ofthe DiSEqC 1.2 functions available.● Select Satellite.● Select any transponder from above satellites andcheck out the Frequency, Symbol Rate, FEC and Polarity.In case problems arise, ask your dealer.Sometimes this transponder may not exist due to broadcasting.It is better to select main transponder among them for thedesired satellite.● Select the Scan Mode : All or Only FreeAfter scanning you will see "Your digital receiver found.."Then, you should press OK key to store all channels into STB.Press EXIT to discard changes.2.4 Selective ScanningThe sub menu “Selective Scanning” will enable scan thechannels automatically from the preprogrammed satellites.To download channels automatically:You can select All/Off/Only Free option mode with the the / keys in each satellite, which can be displayed more bythe PG+/PG- keys.Off : No ScanAll : Scan all the channelsOnly Free : Scan free channels● Press OK key.Selective Scanning menu will be displayed.All the channels in the list from the selected satellite will beautomatically downloaded.After scanning you will see “Your digital receiver found...”.Then, you should press OK key to store all channels into STB.A_GB 10/21/05 2:32 PM Page 18