61ENGLISHIf your DVD player does not seem to be functioning properly, check the items below before you contact a Samsung authorized service center.The built-in micro controller can be influenced by external electrical noise. If you believe this may be the cause of theproblem, turn off the DVD player and then back on.TroubleshootingSymptom CheckPower does not turn on • Make sure the AC power cord is securely plugged into an AC outlet.or suddenly turns off. • Turn the power off and then back on.Battery pack is in place but • Check that the battery pack is charged. If not, recharge it.the power does not turn onor suddenly turns offRemote control won’t work • Check that the battery is inserted in the “+” and “-” directions properly.• The batteries may be dead. Replace them with new batteries.• Check that the signal transmission is directed at the remote control sensor on theDVD player.• Remove the obstacle between the remote control unit and remote control sensor.No picture or sound • Check that the video and audio cables are securely connected.• Check that the disc is a DVD (region number 1 or all), DVD-RW, VIDEO CD, or AUDIO CD.• Do not use a disc that has scratches or dirt.• Check that the label-side of the disc is facing up.• The pick-up lens of the DVD player may be dirty. Contact the service center for lens cleaning.• Check that the TV channel is set to VIDEO or AV if viewing with a TV.Forgot password • Press power on from a cold start with no disc in the unit. Press the STOP and PLAY buttons simulta-neously on the unit for three seconds. The Select Menu Language display will appear. Select thedesired language button. Press the SETUP button on the remote control to select the ParentalMode. The Parental Mode is now unlocked as indicated on the display. Press the DOWN button toselect Parental. Press ENTER and the Create Password display will appear. You can now set yourrating level and change your password to a new number.