Samsung Digimax 420 User Manual

Also see for Digimax 360: User manual User guide

Contents

Samsung Digimax 420 User Manual Manual pdf 92 page image

92Software NotesPlease ensure that you read the instruction manual carefully before use.The attached software is a camera driver and image editing software tool for Windows.Under no circumstances should all or part of either the software or the user manual be reproduced.Copyright for both software is licensed only for use with a camera.In the unlikely event of a manufacturing fault, we will repair or exchange your camera.We cannot, however, be held responsible in any way for damage caused by inappropriate use.Using a Hand-made PC or a PC that has not been guaranteed by the manufacturer is not covered bythe Samsung warranty.Before reading this manual, you should have a basic knowledge of computers and O/S (Operating Systems).Windows is a registered trademark of Microsoft.Macintosh, Mac is the registered trademark of Apple computer, USA.After inserting the CD-ROM provided with this camera into the CD-ROM drive, the following window shouldautomatically run. Before connecting the camera to the PC, you should first install the camera driver.Setting up the application programAccess to the Samsung camera web-site.Click the [Install] menu on the Autorun frame and all of application software is installed.Camera driver : This enables images to transfer between the camera and PC.This camera uses the USB Storage Driver as the camera driver. You can use the camera as a USBcard reader. After installing the driver and connecting this camera to the PC, you can find[Removable Disk] in [Windows Explorer] or [My computer]. A USB Storage Driver is provided onlyfor Windows. A USB Driver for MAC is not included with the Application CD. But you can use thecamera with Mac OS 9.0~10.2.Setting up the camera driver for WINDOWS (p.94)About the software