E-23ENGLISHWired remote controller If an error occurs, is displayed on the wired remote controller. If you would like to see an error code, press the Test button.ExplanationDisplayCompressor down due to protection control of the dischargetemperature sensorControl due to the condenser temperature sensor when coolingmodeError about protectioncontrol of the outdoor unitCommunication and theindoor unit errorsSelf-diagnosis of theindoor and outdoor unitWired remote controllererrorsError about the outdoor unitsensor (Open/Short)Detection during theoperation of the indoor unit(sensing and sending errorsinto the communication data)RemarkError of the low pressure switch (Protection control)Reverse phase error (Protection control)In removing frostError of the outdoor temperature sensor (Open/Short)Error of condensor temperature sensor (Open/Short)Master wired remote controller ā Slave wired remote controllerCOM1/COM2 Cross-installed errorError of setting option for wired remote controller COM2Error of discharge temperature sensor (Open/Short)- System down caused by communication error after completionof tracking- Mismatching of the indoor unit numbers set with thosecommunication after completion of 5 times trackingError of electronic expansion valve close in the outdoor unit(when it is detected more than once)Error of communication between the indoor unit and the wiredremote controllerError of temperature sensor in the indoor unit (Open/Short)Error of the heat exchanger sensor in the indoor unit (Open/Short)Error of electronic expansion valve open in the outdoor unit(when it is detected more than once)