7TRUEtfm www.truemfg.comSTARTUPA. The compressor is ready to operate. Plug in the cooler.B. Temperature controls are factory-set to give freezers anapproxiate temperature of -10°F. Allow unit to function severalhours, completely cooling cabinet before changing the controlsetting.Temperature Control Location and Settings.• Mechanical temperature control is located on rear of unit orbehind access grill.See website for adjustments, sequence of operation, and moreinformation.C. Excessive tampering with the control could lead to servicedifficulties. Should it ever become necessary to replacetemperature control, be sure it is ordered from your TRUEdealer or recommended service agent.D. Good air flow in your TRUE unit is critical. Be careful toload product so that it neither presses against the back wall,nor comes within four inches of the evaporator housing.Refrigerated air off the coil must circulate down the back wall.NOTE: If the unit is disconnected or shut off, wait five minutesbefore starting again.RECOMMENDATION - Before loading product we recommendyou run your TRUE unit empty for two to three days. This allowsyou to be sure electrical wiring and installation are correct and noshipping damage has occurred. Remember, our factory warranty doesnot cover product loss!OPERATION