Samsung GX-MC990CL User Manual

Also see for GX-MC990CL: User manual

Contents

Chapter 2. Installing the Advanced Wireless Gateway2.1 IntroductionThis chapter provides how to properly install the Advanced Wireless Gateway to your serviceprovider’s network and to connect the Advanced Wireless Gateway to your PC and your other ITdevices.2.2 Connect the Wireless GatewayConnecting Coax Cable to your cable splitter and the Gateway1. Choose an appropriate and safe location to install the Gateway.2. Power off your PC and other IT device.3. Connect the active RF coaxial cable from your service provider to the coax connector labeledCABLE/MoCA on the back of the Wireless Gateway.4. If your Wireless Gateway supports telephone service , connect one end of a telephone jumpercable to a telephone outlet in your home. Then connect the other end of the jumper cable to theappropriate RJ-11 TEL1 or TEL2 port on the back of the Wireless Gateway.5. Connect your PC to the Wireless Gateway using the Ethernet Connection or the WirelessConnection.6. Connect the DC jack end of the Adapter into the DC plug on the back of the Gateway.Connect the power code to adpter and an electrical outlet.The Wireless Gateway will perform an automatic search to locate and sign on to the broadband datanetwork. This process may take up to 2-5 minutes. The Wireless Gateway will be ready for use whenthe Power, DS,US, and Online LEDs on the front panel of the Wireless Gateway stop blinking andremain on continuously.7 . If your wireless devices uses wireless networking, the WiFi 2.4 G or WiFi 5 GHz LED on theWireless Gateway should be on or blinking.8 Finally, the installation is complete, and you can begin surfing the Internet sites.