Caution! Be careful not to damage or detach the multipurposejack cover. A damaged or missing cover can result inwater damage to the device.2. Plug the flat end of the Travel Charger into the Power/Accessory Interface port (2) and the other end into astandard AC wall outlet.3. When charging is finished, remove the flat end fromthe interface connector port on the phone.Important! Before closing the multipurpose jack cover, checkto see if there is any foreign substance such asdust on sand on the rubber seal.4. Tightly close the multipurpose jack cover when you arefinished so that no water can enter the port.Warning! Please note that a touch screen responds best to alight touch from the pad of your finger. Usingexcessive force or a metallic object when pressingon the touch screen may damage the temperedglass surface and void the warranty. For moreinformation, refer to “Standard Limited Warranty”on page 224.Important! Failure to unplug the wall charger before youremove the battery, can cause damage to thephone.Low Battery IndicatorWhen the battery is weak and only a few minutes of talk timeremain, the battery icon blinks and the device sounds awarning tone at regular intervals. In this condition, yourphone conserves its remaining battery power, not by turningoff the backlight, but by entering the dimming mode. For aquick check of your battery level, glance at the batterycharge indicator located in the upper-right corner of yourdevice’s display. Solid color indicates a full charge.( )( )Getting Started 11
