12Maintaining water and dust resistanceThis device is rated IP67 using the Ingress Protection rating system.Your device has been tested in a controlled environment and shown to be water and dust resistant in certaincircumstances (meets requirements of classification IP67 as described by the international standard IEC 60529- Degrees of Protection provided by Enclosures [IP Code]; test conditions: 15-35°C, 86-106 kPa, 1.0 meters,for 30 minutes). Despite this classification, your device is not impervious to water damage in any situation. It isimportant that all compartments are closed tightly.Note: If any liquid is found to have entered your device components or an internally sealed system, thiscondition will void your device warranty.● Follow these tips carefully to prevent damage to the device.● Any device which uses accessible compartments or ports that can be opened should have these sealed orclosed tightly to prevent liquid from entering the system.● Whenever your device gets wet, dry it thoroughly with a clean, soft cloth.● Do not expose the device to salt water or ionized water, or to water over 1.0 meters deep for more than30 minutes. If your device is exposed to fresh water, dry it thoroughly with a clean, soft cloth. If thedevice is exposed to any liquid other than fresh water, rinse the device with fresh water immediatelyand dry it thoroughly with a clean, soft cloth. Failure to rinse the device in fresh water and dry it asinstructed may cause the device to suffer from operability or cosmetic issues.● Do not expose the device to water at high pressure.● If the device is dropped or receives an impact, the water and dust resistant features of thedevice may be damaged.