Samsung HH105ECM Installation Manual

Also see for HH105ECM: Owner's instructions Owner's instructions Service manual

Indoor unit installationENGLISHE-71 Place the pattern sheet on the ceiling at the spot where you want toinstall the indoor unit.2 Insert bolt anchors. Use existing ceiling supports or construct a suitablesupport as shown in figure.3 Install the suspension bolts depending on the ceiling type.4 Screw eight nuts to the suspension bolts making space for hangingthe indoor unit.5 Hang the indoor unit to the suspension bolts between two nuts.6 Screw the nuts to suspend the unit.7 Adjust level of the unit by using measurement plate for all 4 sides.Ensure that the ceiling is strong enough to supportthe weight of the indoor unit.Before hanging the unit, test the strength of eachattached suspension bolt.IMPORTANTYou must install the suspension bolts more than fourwhen installing the indoor unit.IMPORTANT◆ Tubing must be laid and connected inside the ceiling whensuspending the unit. If the ceiling is already constructed,lay the tubing into position for connection to the unit beforeplacing the unit inside the ceiling.NNNN oooo tttt eeee◆ Since the diagram is made of paper, it may shrink or stretchslightly due to temperature or humidity. For this reason, beforedrilling the holes maintain the correct dimensions between themarkings; refer to page 6.NNNN oooo tttt eeee◆ For proper drainage of condensate, give a 10mm slant to theleft or right side of the unit which will be connected with the drainhose, as shown in the figure. Make a tilt when you wish to install thedrain pump, too.NNNN oooo tttt eeeeConcreteSuspension bolt(M8)-field supplyHole in anchorHole in plugInsertCeiling supportDrain hose connection portRubber10mm