Samsung HT-DB120 Instruction Manual

Also see for HT-DB120: Instruction manual Instruction manual Manual Instruction manual Instruction manual

14Connecting the Video to TV13CONNECTIONSThe cooling fan dissipates the heat generated inside the unit so that the unit can be operatednormally. The cooling fan is activated automatically to supply cool air to the unit.Please observe the following cautions for your safety.• Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could riseand may damage it.• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with anewspaper or cloth, heat may build up inside the unit and fire may result.)Cooling FanConnecting the FM and AM(MW) AntennasFM antenna connection AM (MW) antenna connection1. Connect the FM antenna supplied to the FM 75ΩCOAXIAL terminal as a temporary measure.2. Slowly move the antenna wire around until youfind a location where reception is good, thenfasten it to a wall or other rigid surface.• If reception is poor, connect an outdoor antenna.Before attaching a 75Ω coaxial cable (with a standardtype connector), disconnect the supplied FM antenna.1. Connect the AM loop antenna suppliedto the AM and terminals.2. If reception is poor, connect an outdoorsingle vinyl-covered wire to the AMterminal. (Keep the AM loop antennaconnected).Snap the tabs on the loop into theslots of the base to assemble theAM loop antenna.VOLTAGESELECTORANTENNA1 2 3If FM reception is poor,connect an outdoor FMantenna (not supplied).FM Antenna (supplied)AM Loop Antenna(supplied)If AM reception is poor, connect anoutdoor AM antenna(not supplied).VOLTAGESELECTORCompositeVideoComponentVideoS-VideoTV• When the Progressive scan mode is selected, the VIDEO and S-VIDEOoutputs do not feed any signals.NoteComposite Video (Good Quality)Connect the supplied video cable from the VIDEO OUT jack on the back panel of thesystem to the VIDEO IN jack on your television.S-Video (Better Quality)If you television is equipped with an S-Video input, connect an S-Video cable (not supplied)from the S-VIDEO OUT jack on the back panel of the system to the S-VIDEO IN jack onyour television.Component Video (Best Quality)If your television is equipped with Component Video inputs, connect a component videocable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to thecorresponding jacks on your television.* Depending on your TV, Component Video input connectors may be marked as DVD Video input connectors.