Setting the Delay TimeIf the speakers cannot be placed at equal distances from the listening position, you can adjust thedelay time of the audio signals from the center and rear speakers.53 54Setting up the Speaker Delay TimeWhen 5.1CH Surround Sound is played, you can enjoy the best sound ifthe distance between you and each speaker is the same. Since the soundsarrive at the listening position at different times depending on theplacement of speakers, you can adjust this difference by adding a delayeffect to the sound of the Center Speaker and Surround Speakers.SETUP21 In Stop mode,press MENUbutton.Press Cursor buttonto move to ‘Audio’ andthen press ENTERbutton.• You can set the delay time for Cbetween 00 and 05mSEC and forLS and RS between 00 and15mSEC.43 5Press Cursor buttonto move to ‘DELAYTIME’ and then pressENTER button.Press Cursor , ,, buttons to moveto the desiredspeaker and thenpress ENTER button.Press Cursor ,to set the Delaytime.0 ms3 ms6 ms9 ms12 ms15 ms• Setting REAR (SURROUND) SPEAKERSIf the distance of Df is equal to the distance of Dsin the figure, set the mode as 0ms. Otherwise,change the setting according to the table.• Setting CENTER SPEAKERIf the distance of Dc is equal to or longer than thedistance of Df in the figure, set the mode as 0ms.Otherwise, change the setting according to the table.Distance between Df and Dc Delay TimeDelay Time0 ms1 ms2 ms3 ms4 ms5 msDistance between Df and Ds0.00 m0.34 m0.68 m1.02 m1.36 m1.70 m0.00 m1.02 m2.04 m3.06 m4.08 m5.10 m• With (Dolby Pro Logic II), the delay time may be different for each mode.• With AC-3 and DTS, the delay time can be set between 00 and 15mSEC.NoteDf: The distance from FRONT SPEAKERDc: The distance from CENTER SPEAKERDs: The distance from SURROUND SPEAKERIdeal CENTERSPEAKER placementIt is desirable to place all speakers within this circle.IdealSURROUNDSPEAKERplacement