Samsung HT-DS760T Instruction Manual

Also see for HT-DS760T: Service manual Service manual Instruction manual Instruction manual

Contents

6463Setting the RRSS(Rear Reflecting Surround System)• By setting up the RRSS function just once, the speaker distance, channel level, and rear soundreflection effect are automatically set and create an optimal listening environment.• This function works only in DVD/CD mode.SETUP2143Connect the RRSSMicrophone to theRRSS input jack.Place the RRSSMicrophone at thelistening position.Press the RRSSbutton.When "REMOVE MIC"appears on the display,disconnect the RRSSMicrophone.• The RRSS button works as the RRSS setup function shown above if the RRSS Microphone is connected, and works as the rear soundreflection effect function if the microphone is removed.• If you are installing the system for the first time or if you have initialized the system, "NO MEASURED DATA" will appear on the displaywhen you press the RRSS button without connecting the RRSS Microphone.• During the RRSS setup, the output volume of the tone is fixed and you cannot use the volume control buttons to adjust the output level.• If you remove the RRSS Microphone during the RRSS setup, the setup will be cancelled.• Place the front and left speakers (L/R) toward the side walls so that the rear speaker sound is reflected against the walls.Note• If the system is installed at a location where sound cannotbe reflected (e.g., an open space without walls), the speakerdistance, channel level, and rear sound reflection effect maybe set incorrectly during the RRSS setup.Caution* This drawing is provided for illustrationpurposes only and the actual appearanceof the items depicted may vary.L: Front Speaker (L) R: Front Speaker (R)C: Center Speaker SW: SubwooferLS: Rear Speaker (L) RS: Rear Speaker (R)To select the RRSS that you have setBriefly press the RRSS button.(If you have set the RRSS for the first time according toSteps 1 to 3 on the previous page)• Your selection will toggle between "REAR REFLECTINGON" and "REAR REFLECTING OFF" on the display.• Select "REAR REFLECTING ON" to listen using theRRSS setting and select "REAR REFLECTING OFF" tolisten to the disc currently being played in its originalsetting.• A speaker tone will be heard oncefrom each speaker in the order ofL ➝ C ➝ R ➝ RS ➝ LS ➝ SW, andthen the newly set error tone will beheard again from L ➝ R.• An optimal listening environment willbe set up automatically.• It takes about 2 minutes to completethe RRSS setup.Tone OutputA piano sound will be heard and thesetup will be completed.To enable or disable the sound logoWhen you turn on the power, a sound logo will be heard,indicating that the disc reading is completed and the player isin its optimal condition to play the disc.1. Press and hold the RRSS button.• "S.LOGO ON" or "S.LOGO OFF" appears on thedisplay.2. Briefly press the RRSS button.• Each time you press the button, your selection togglesbetween "S.LOGO ON" and "S.LOGO OFF".• Select "S.LOGO ON" to enable the sound logo andselect "S.LOGO OFF" to disable the sound logo.To check the RRSS that you have set1. Press and hold the RRSS button twice.• "CHECK" appears on the display.2. Next,briefly press the RRSS button.• The speaker distance and level value for each channelwill be displayed.To cancel the RRSS setupPress the RRSS button.• The tone output stops, "CANCEL" appears on thedisplay, followed by "REMOVE MIC", and then thesetup will be cancelled.HT-DS960 HT-DS760T