3635Speaker SetupTo set up Speaker Balance1 Use the Left/Right ( / ) button to raise orlower the output level of the chosenspeaker(s).Example: 5.1CH Sound SetupSound EditSubwoofer Center SpeakerRear Speaker+— +—+—Press the Sound Edit button.• Each time the button is pressed the selectionswitches as shown below.2The display changes depending on the current audio outputmode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).While in DSP or PRO LOGIC mode, TEST TONE mayoperate differently for VCDs or CDs.Speaker Setting Methods• The test signal will be sent to the Left Front, Center, Right Front,Right Rear, Left Rear in that order.Test TonePress the Test Tone button.To End the Speaker SetupTest Tone• Press the Test Tone button again.LLS RSC RPRO LOGICLINEAR PCML C RLSLFES RSD I G I T A LPRO LOGICLINEAR PCML C RLSLFES RSD I G I T A LPRO LOGICLINEAR PCML C RLSLFES RSD I G I T A LPRO LOGICLINEAR PCML C RLSLFES RSD I G I T A LPRO LOGICLINEAR PCML C RLSLFES RSD I G I T A LOFF, range of – 6 ~ 0OFF, range of – 6 ~ 0range of – 6 ~ – 00 ~ +6range of – 6 ~ – 00 ~ +6range of – 6 ~ – 00 ~ +6Front Speakers: L level, R levelRear Speakers: L level, R levelCenter SpeakerRear SpeakersSubwoofer Speaker• You can adjust various settings by using theircorresponding buttons on the remote control unit.Selecting Dolby Pro LogicConverts Dolby Surround encoded 2-channel sound so that it can be heard over 3 or 5 speakersplus the Subwoofer.Pro Logic mode can also be enjoyed when in DVD mode or when playing Dolby Digital or PCMmaterial that is Dolby Surround encoded.Pro LogicPress the Pro Logic button.1 2Press the Function Selection button toselect the desired function.Press the Pro Logic button.• Select from FM, AM, DVD and AUX IN. • Each time the Pro Logic button is pressedLFECSPRO LOGICL RPRO LOGICL RL RCLFECLFESPRO LOGICPRO LOGIC : Left, Center, Right, Subwoofer andSurround Channel3-STEREO : Left, Center, Right and SubwooferChannelSTEREO : Left, Right and Subwoofer Channel