English - 82Problem Possible SolutionImage is not stable and mayappear to vibrate when you havea computer connected to the PCinput.If the setting is not correct, use your computer utility program to change the displaysettings.Your TV supports multiscan display functions within the following frequency domain:- Horizontal frequency (KHz): 30~60- Vertical frequency (Hz): 60~75- PC Maximum refresh rate (at 60 Hz): 1920 x 1080Image is not centered on thescreen.Adjust the horizontal and vertical position.The screen position must be adjusted on the output source (i.e. STB) with a digital signal.The picture appears distorted in thecorner of the screen.If Screen Fit is selected with some external devices, the picture may appear distorted inthe corner of the screen. This symptom is caused by the external devices, not TV.The ‘Resets all settings to thedefault values.’ message appears.This appears when you press and hold the EXIT button for a while. The product settingsare reset to the factory defaults.This TFT LCD panel uses a panel consisting of sub pixels (6 220 800) which require sophisticated technology to produce.However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of theproduct.Installing the Stand1. Attach your LCD TV to the stand.Two or more people should carry the TV.Make sure to distinguish between the front and back of the stand whenattaching it.To make sure the TV is installed on the stand at a proper level, do not applyexcess downward pressure to the upper left of right sides of the TV.2. Fasten screws at position 1 and then fasten screws at position 2.Stand the product up and fasten the screws. If you fasten the screws withthe LCD TV placed down, it may lean to one side.Disconnecting the Stand1. Remove screws from the back of the TV.2. Separate the stand from the TV.Two or more people should carry the TV.. Cover the bottom hole with the cover.N¦NNNN¦N21
