English - When unable to connect to an APYour TV may fail to locate an AP that is configured as a private SSID type. In this case, please change the AP settings and tryagain. If your Internet service provider has registered the MAC address of the device used to connect to the Internet for thefirst time and authenticates the MAC address each time you connect to the Internet, your TV may not be able to connect to theInternet as the MAC address differs from that of the device (PC).In this case, ask your Internet service provider about the procedures to connect devices other than your PC (such as your TV)to the Internet. If you cannot connect to the Internet even if you have followed the procedures of your Internet service provider,please contact a Samsung Electronics at 1-800-SAMSUNG.Select a networkAccess Point: You can select the IP sharer to use when using a wireless network.If a wireless Access Point is not in the Access Point list, press the Red button.When the connection is made, you will be returned to the screen automatically.If you have selected an Access Point with a security authentication:The Security Key input screen appears. Enter the security key and press theBlue button on the remote control.If security encryption type is WEP, 0~9, A~F will be available when you inputsecurity key.Connecting WPS (Wi-Fi Protected Setup)If Security Key is already set: In access point list, select WPS.You can select PBC, PIN, Security Key.Connecting by using PBC: Select a PBC (Push Button Configuration). Press the PBCbutton on the AP (access point) within 2 minutes, and wait for connection.Connecting by using PIN: Select a PIN (Personal Identification Number).The message showing the PIN Code is displayed. Input the PIN Code at APdevice within 2 minutes. Select OK and wait for connection.Try again if connecting operation doesn’t workWhen the connection is not established although tried again, reset the access point. Please refer to a manual of eachaccess point.Connecting by using Security Key: When selecting Security Key, the input window isdisplayed. Input the security key and press Blue button.Try again if connecting operation doesn’t work.If Security Key is not set: When the security setting of AP that supports WPS is NONE,you can select PBC, PIN, None Security. None Security is capable of connecting to APdirectly without using WPS function.Process of PBC, PIN is same as above. Refer to if Security Key is already set.Try again if connecting operation doesn’t work.N●NNNN●NNNNN●NNWireless Network SetupU Move E Enter R ReturnSelect a network 3/9SearchAd-hocssonjeeAP_1Ap_2PBCPINSecurity KeyCancelPress the PBC button on the access point.Access Point Name : AP_1Press OK After input TV’s Pincode in the accesspoint’s setup.Access Point Name : AP_1PIN Code : 12345678CancelOKWireless Network Setupn Move `~9 Number E Enter R ReturnSecurity KeyNumberLowercaseDeleteDoneAHOVBIPWCJQXDKRYELSZFMTGNUWireless Network SetupU Move E Enter R ReturnSelect a network 3/9SearchAd-hocssonjeeAP_1Ap_2PBCPINNone SecurityWireless Network Setupn Move `~9 Number E Enter R ReturnSecurity KeyNumberDeleteDoneA B C D E F
