Samsung MH020FPEA Installation Manual

Also see for MH020FPEA: User manual Service manual Service manual Service manual Service manual

Contents

E-10To install the drain hose, proceed as follows.1 If necessary, connect the 2-meter extension to the drain hose.2 If you are using the extension, insulate the inside part of the extensiondrain hose with a shield.3 Pass the drain hose under the refrigerant piping, taking care to keep thedrain hose tight.4 Pass the drain hose through the hole in the wall, making sure that it issloping downwards, as shown in the illustrations above.➢ The hose will be fixed permanently into position once thewhole installation has been tested for gas leaks; refer toinstallation manual of the outdoor unit.Installing and Connecting the Indoor Unit Drain HoseCare must be taken when installing the drain hose for the indoor unit to ensure that any condensationwater is correctly drained outside. When passing the drain hose through the 65 mm hole drilled in thewall, check that none of the following situations occur.The hose mustNOT slopeupwards.The end of the drainhose must NOT beplaced in water.Do NOT bend thehose in differentdirections.Keep a clearance ofat least 5 cm betweenthe end of the hoseand the ground.Do NOT place theend of the drain hosein a hollow.5 cmless DitchINSTALLING THE INDOOR UNITShieldDrain hose Extension drain hose