E-27ENGLISHSolving Common ProblemsBefore contacting the after-sales service, perform the following simple checks.They may save you the time and expense of an unnecessary call.Problem Explanation/SolutionThe air conditioner does notoperate at all. Check if power is on and operate the air conditioner again. Check if the circuit breaker is switched off. Check if Off Timer is set.The temperature is not adjusted. Check if you selected the Fan mode.The air conditioner does not operatein the HEAT mode. Check if the air conditioner is cooling only model. Check if the remote control is for cooling only model.The cool(warm) air does not comeout from the air conditioner. Check if set temperature higher(lower) than current temperature. Check if you selected the Fan mode. Select the Cool, Heat, Auto or Drymode. Check if the air filter is blocked by dirt. Clean the air filter regularly. Check if the there is cover on the outdoor unit or any obstacle.Remove the cover or obstacle. Check if you installed the air conditioner under direct sunlight. The window or door may be opened. Check if you turn on the air conditioner just now.It takes about 3 minutes to cool or heat the room. Check if the drain pipe is too long.The fan speed is not adjusted. In Dry mode, the fan speed is selected automatically.The remote control doesnot operate. Check if the battery is discharged. Replace the battery. Check if the remote control sensor is blocked. Check if the air conditioner is placed near strong light.The Timer is not set. Check if you pressed the button after selecting time.Odor is permeated in theroom during operation. Check if you use the air conditioner in smoky area or there is a smell.Ventilate the room or select the Fan mode for 1~2 hours.The indoor unit indicatorflashes. Press the button to turn on the air conditioner again.Switch the circuit breaker off and switch on it again.Strange sound is heard fromthe air conditioner. The sound is heard when the refrigerant gas flow is changed dependingon the use of the air conditioner. When you press the button, noise may be heard that theair conditioner sense the airflow blade.Water drops from the outdoorunit connection part. Water may form due to the difference of the temperature.AUTO- DIAGNOSTIC FUNCTIONThis air conditioner has an auto-diagnostic function in case a failure will happen.Occurring error, the Lamp is blink.Before contacting customer call center green number, please ask to installer tomake a double check of installation unless there’s a full evidence of SAMSUNGproduct problem.