I NTRODUCTION 1.71Cancel buttonIf you press the Cancel button in Ready mode, this LED is onand the Toner Save mode is enabled.If you press this button once again, this LED is off and theToner Save mode is disabled.If the On Line/Error and Toner Save LEDs blink, yoursystem has some problems.To solve the problem, see “Troubleshooting Error Messages”on page 5.16LED DescriptionFunction DescriptionPrinting demo page In Ready mode, press and hold this button for about 2seconds until all LEDs blink slowly, and release.Manual feeding Press this button each time you load a sheet of paper in thetray, when you select Manual Feed for Source from yoursoftware application.For detailed information, see “Using Manual Feed Mode” onpage 3.7.Canceling print job Press this button during printing. The On Line/Error LEDblinks while the print job is cleared from both the printerand the computer, and then return to Ready mode. Thismay take some time depending on the size of the print job.In Manual Feed mode, you can’t cancel the print job bypressing this button.For detailed information, see “Using Manual Feed Mode” onpage 3.7.Toner Save modeon/offIn Ready mode, press this button to turn the Toner Savemode on or off.For detailed information, see Software User’s Guide andpage 4.5.
