Samsung ML-85G Operating Instructions Manual

Also see for ML-85G: Product guide Installation guide

Contents

FCC COMPLIANCE NOTICEIC COMPLIANCE NOTICEThis equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC rules. These limits are designedto provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception,which can be determined by turning the suspected offending equipment off andon, the user is encouraged to try to correct the interference by one or more ofthe following measures:l Re-orient or relocate the receiving antenna.l Increase the separation between the offending equipment and the receiver.l Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.l Consult the dealer, a radio/TV technician, or an Amateur Radio Operatorfor help.Shielded interface cables and I/O cords must be used for this equipment tocomply with the relevant FCC regulations.Changes or modifications not expressly approved in writing by Samsung mayvoid the user’s authority to operate this equipment.The Federal Communications Commission has developed a useful bookletentitled, “How to Identify and Resolve Radio/TV Interference Problems”. Thisbooklet is available from the Superintendent of Documents, U.S. GovernmentPrinting Office, Washington, D.C. 20402, Stock No. 004-000-00345-4.This Class B digital apparatus meets all requirements of the CanadianInterference–Causing Equipment Regulations of ICES–003.Cet appareil numérique de la Classe B respecte toutes les exigences duRèglement ICES–003 sur le Matériel brouilleur du Canada.ML-85G IB(SSA) 2/9/99 11:15 AM Page 2