Samsung MM-C6DAB Instruction Manual

Contents

6Rear Panel View1. FM Aerial Connector Terminal2. AM Aerial Connector Terminals3. Loudspeakers Connector Terminals4. AUX-Input5. DAB Aerial Connector Terminal61243GB7The main lead must be plugged into an appropriate socket.Before plugging your system into a main socket, you must checkthe voltage.Plug the main lead into an appropriate socket.Press the Standby/On button to switch your micro-component system on.To take full advantage of your new micro-component system, fol-low these installation instructions before connecting the unit.Install the system on a flat, stable surface.Never place this unit on carpeting.Never place this unit in an outdoor area.Maintain an open space of approximately 6 inches (15 cm) on thesides and rear of the system, for ventilation purposes.Make sure that you have enough room to open the compact disccompartment easily.Place the loudspeakers at a reasonable distance on either side ofthe system to ensure good stereo sound.Direct the loudspeakers towards the listening area.For optimum performance, make sure that both speakers are placedat an equal distance above the floor.Where to Install YourMicro-Component SystemConnecting your System to thePower SupplyInsert or replace remote control batteries when you:Purchase the micro-component systemFind that the remote control is no longer operating correctlyWhen replacing the batteries, use a new set of batteries andnever mix alkaline and manganese batteries.Place your thumb on the position marked on the batterycompartment cover (rear of the remote control) and push the cover inthe direction of the arrow.Insert two AAA, LR03 or equivalent batteries, taking care to respectthe polarities:+ on the battery against + in the battery compartment– on the battery against – in the battery compartmentReplace the cover by sliding it back until it clicks into position.If you will not be using the remote control for a long time,remove the batteries to prevent corrosion.123216Inserting Remote Control BatteriesGB5