GB2Safety WarningsCLASS 1 LASER PRODUCTThis Compact Disc player is classified as a CLASS 1LASER product.Use of controls adjustments or performance of proceduresother than those specified herein may result in hazardousradiation exposure.CAUTION-INVISIBLE LASER RADIATION WHEN OPENAND INTER LOCKS DEFEATED, AVOID EXPOSURE TOBEAM.WARNING: TO REDUCE THE RISK OF FIRE ORELECTRIC SHOCK, DO NOT EXPOSETHIS APPLIANCE TO RAIN OR MOISTURE.CAUTION: TO PREVENT ELECTRIC SHOCK, MATCHWIDE BLADE OF PLUG TO WIDE SLOT,FULLY INSERT.CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE REAR COVER, NO USERSERVICEABLE PARTS INSIDE, REFER SER-VICING TO QUALIFIED SERVICEPERSONNEL.RISK OF ELECTRIC SHOCK.DO NOT OPENCAUTIONCLASS 1 LASER PRODUCTKLASSE 1 LASER PRODUKTLUOKAN 1 LASER LAITEKLASS 1 LASER APPARATPRODUCTO LASER CLASE 1This symbol indicates that dangerous voltage constituting of a risk of electric shock is present withinthis unit.Wiring the Mains Power Supply Plug(UK Only)IMPORTANT NOTICEThe mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is indicated on the pin faceof the plug and, if it requires replacing, a fuse approved to BS1362 of the same rating must be used.Never use the plug with the fuse cover omitted. If the cover is detachable. If a replacement fuse cover is required, it must be of the samecolour as the pin face of the plug. Replacement covers are available from your dealer.If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power point, you should obtaina suitable safety approved extension lead or consult your dealer for assistance.However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug. Do NOT connect the plug toa mains socket as there is a risk of shock hazard from the bared flexible cord.IMPORTANTThe wires in the mains lead are coloured in accordance with the following code:–BLUE = NEUTRAL BROWN = LIVEAs these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed as follows:–The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire colouredBROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER E OR BYTHE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.This symbol indicates that there are important operating and maintenance instructions in the ownersmanual accompanying this unit.