Samsung NS***CDXEA Series Installation Manual

Contents

16AStep 1. Entering mode to set option1. Remove batteries from the remote controller.2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.3. Check if you have entered the option setting status.Step 2. The procedure of option settingAfter entering the option setting status, select the option as listed below.Option setting is available from SEG1 to SEG 24• SEG1, SEG7, SEG13, SEG18 arenot need to be set at MR-DH00. They are the page options which were used at theprevious other remocons.• Set the each 2 bit option code in order except page options.For example : SEG2, 3  SEG4, 5  SEG6, 8  SEG9, 10  SEG11, 12  SEG 14, 15  SEG 16, 17  SEG 18, 20 SEG 21, 22  SEG23, 24.High Temp Button High Fan ButtonMode changeLow Temp Button Low Fan ButtonEntering mode forsetting optionOption setting modeThe procedure of setting optionSetting an indoor unit address and installation option▶ Set the indoor unit address and installation option with remote controller option.Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at thesame time.You need to set twice when setting indoor unit address and installation option.▶ Please use the proper wireless remocon which can set 24 digit option code. Following is the instructions of setting optioncode with wireless remocon of MR-DH00. (MR-AH01 can be used for operating but cannot be used for setting the installationoption because only 12 digit option setting is available.▶ Please refer to the wired remocon installation manual for setting with the wired remocon.On(SEG1~12) Off(SEG13~24)SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG120 X X X X X 1 X X X X XSEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG242 X X X X X 3 X X X X X