Samsung NS071LDXEA Manual

Also see for NS035LDXEA: Service manual

Contents

Samsung NS071LDXEA Manual Manual pdf 3 page image

3ENGLISHWhen deciding on the location of the air conditioner with the owner, the following restrictions must be taken into account. Our units should be installed in compliance with the spaces shown in the installation manual, to ensure accessibility from bothsides and allow repairs or maintenance operations to be carried out. The unit’s components should be accessible and easy todisassemble without endangering people and objects.For this reason, when provisions of the installation manual are not complied with, the cost required to access and repair the units(in SAFETY CONDITIONS, as set out in prevailing regulations) with harnesses, ladders, scaffolding or any other elevation system willNOT be considered part of the warranty and will be charged to the end customer.Power supply line, fuse or circuit breaker Always make sure that the power supply is compliant with current safety standards. Always install the air conditioner in compliancewith current local safety standards. Always verify that a suitable grounding connection is available. Verify that the voltage and frequency of the power supply comply with the specifications and that the installed power is sufficientto ensure the operation of any other domestic appliance connected to the same electric lines. Always verify that the cut-off and protection switches are suitably dimensioned. Verify that the air conditioner is connected to the power supply in accordance with the instructions provided in the wiring diagramincluded in the manual. Always verify that electric connections (cable entry, section of leads, protections…) are compliant with the electric specificationsand with the instructions provided in the wiring scheme. Always verify that all connections comply with the standards applicableto the installation of air conditioners. Devices disconnected from the power supply should be completely disconnected in the condition of overvoltage category.Do NOT install the air conditioner in a location where it will come into contact with the following elements : Combustible gases Saline air Machine oil Sulphide gas Special environmental conditionsIf you must install the unit in such conditions, first consult your dealer.Avoid installing the air conditioner : In areas where it is exposed to direct sunlight. Close to heat sources. In damp areas or locations where it could come into contact with water. (for example rooms used for laundry) In areas where curtains and furniture could affect the supply and discharge of air. Without leaving the required minimum space around the unit. (as shown in the drawing) In scarcely ventilated areas. On surfaces that are unable to support the weight of the unit without deforming, breaking or causing vibrationsduring the use of the air conditioner. In a position that does not enable the condensate drainage pipe to be correctly installed. (at the end of theinstallation. It is always essential to check the efficiency of the drainage system)GeneralPreparation for installation Make sure that you earth the cables.- Do not connect the earth wire to the gas pipe, water pipe, lighting rod or telephone wire. If earthing is notcomplete, electric shock or fire may occur. Install the circuit breaker.- If the circuit breaker is not installed, electric shock or fire may occur. Make sure that the condensed water dripping from the drain hose runs out properly and safely. Install the power cable and communication cable of the indoor and outdoor unit at least 1m away from the electric appliance. Install the indoor unit away from lighting apparatus using the ballast.- If you use the wireless remote control, reception error may occur due to the ballast of the lighting apparatus. Do not install the air conditioner in following places.- Place where there is mineral oil or arsenic acid. Resin parts flame and the accessories may drop or water mayleak. The capacity of the heat exchanger may reduce or the air conditioner may be out of order.- The place where corrosive gas such as sulfurous acid gas generates from the vent pipe or air outlet.The copper pipe or connection pipe may corrode and refrigerant may leak.- The place where there is a machine that generates electromagnetic waves. The air conditioner may not operatenormally due to control system.- The place where there is a danger of existing combustible gas, carbon fiber or flammable dust.The place where thinner or gasoline is handled. Gas may leak and it may cause fire.