Samsung NV9 User Manual

Also see for NV9: Quick start manual Quick start manual Quick start manual Quick start manual Quick start manual

Contents

Appendix 84Camera maintenanceAbout the batteryUse only Samsung-approved batteries.Battery specificationsMode SLB-10AType Lithium-ion batteryCell capacity 1050 mAhVoltage 3.7 VCharging time(when the camera is switched off)Approx. 150 minBattery lifeAverage time Test conditions(when the battery is fully charged)PhotosApprox. 120 min(Approx. 240photos)Take photos under the followingconditions: in the 2 mode, 10Mresolution, Fine quality, OIS on.1. Set the flash option to (Fill In), take asingle shot, and zoom in or out.2. Set the flash option to (Off), take asingle shot, and zoom in or out.3. Perform steps 1 and 2 for 30 secondsand repeat for 5 minutes. Then turn offthe camera for 1 minute.4. Repeat steps 1 to 3.Videos Approx. 120 min Record videos at 640x480 resolution and30 fps.Average time Test conditions(when the battery is fully charged)MP3 Approx. 310 min Play files with the screen turned off.PMP Approx. 230 min Play files with normal playback.The figures above are measured by Samsung’s standards and may differdepending on usage.Notes about charging the batteryIf the indicator light is off, make sure that the battery is insertedcorrectly.Turn off your camera when charging.Turn on your camera after charging the battery for more than 10minutes.Using flash or recording videos uses up the battery quickly. Chargethe battery until the indicator light turns green.If the indicator light blinks in red or is off, reconnect the cable orremove the battery and insert it again.If you charge the battery when it is warm, the indicator light may turnorange. Charging will start when the battery cools down.Notes about charging with a computer connectedUse the provided USB cable only.The battery may not be charged when:- you use a USB hub- other USB devices are connected to your computer- you connect the cable to the port on the front side of yourcomputer- the USB port of your computer does not support the Power outputstandard (5 V, 500 mA)••••••••