116Wireless networkYou can send photos or videos that you captured with the camera to aPC wirelessly. The Auto Backup feature works only with the WindowsOS.Installing the program for Auto Backupon your PC1 Install Intelli-studio on the PC. (p. 141)2 Connect the camera to the PC with the USB cable.3 Click OK on the pop-up window.• The Auto Backup program is installed on the PC. Follow theon-screen instructions to complete the installation.4 Remove the USB cable.5 Connect the camera to the PC again with the USB cable.• The camera stores information about the PC, so that the cameracan send files to the PC.Before installing program, ensure that the PC is connected to a network.If no internet connection is available, you must install the program from theprovided CD.Sending photos or videos to a PC1 Rotate the mode dial to B.2 Select .• You must configure the backup PC information to use the AutoBackup feature. For more details, refer to “Installing the programfor Auto Backup on your PC”. (p. 116)3 Press [m] to set options.• To turn off your PC automatically after the transfer is complete,select → Shut down PC after backup → On.• To view the help for the Auto Backup function, select →Guide.4 Press [o] to start the backup.• To cancel sending, press [o].• You cannot select individual files to backup. This function backsup only new files on the camera.• The backup's progress will be shown on the PC monitor.• When the transfer is completed, the camera will turn offautomatically in approximately 30 seconds. Select Cancel toreturn to the previous screen and prevent the camera fromturning off automatically.Using Auto Backup to send photos or videos
