Samsung PDP-MONITOR (PLASMADISPLAYPANEL) Owner's Instructions Manual

English - 19How to Install the Wall Mount Bracket3 Tighten the screws of the plastic hanger (shownin picture 2) to the back side of the PDPMonitor.4 Remove the Safety Pins. Fasten the 4 plasticlatches assembled at step (#) on the back side ofthe PDP Monitor using the guide holes of the wallmount, push (!) and hook (@) down to secure thePDP Monitor on the wall mount as illustrated.Secure the PDP Monitor by inserting the SafetyPins, not to fall from the wall mount.PDP Monitor panelWall attachmentpanel bracketWallHow to Adjust Mounting Angle➢ Please secure the mounting bracket on the wall surface after setting its angle at 0°1 Secure the SET to the wall mount bracket.(Please refer to thefollow ing instructions.)2 Set the angle by pulling the upper end of the SET attached tobracket in the direction of the arrow. (Refer to the illustrationon the right.)3 The angle can be adjusted from 0° to 15° by ±2°.Hold onto the middle of the PDPMonitor to adjust the angle (not thesides of the PDP Monitor).Connecting External Devices to the PDP Monitor➢ To connect external devices such as a DVD or a Home Theater System to the PDP Monitor, please refer tofollowing instructions:1 Be sure to remove the safety pins underneath the PDPMonitor.➢ If the safety pins are not removed, the angle cannot beadjusted. Any attempt to do so may cause damage tothe PDP Monitor.2 Hold onto the bottom of the PDP Monitor and pull forwardfully as directed by the arrow as illustrated) to adjust theangle. (0°~20° by 2°) Insert the Safety Pins to the frontguide holes on both sides as illustrated in figure @.➢ Viewing the PDP Monitor after connecting the externaldevices Remove the Safety Pins to adjust the angle to0°, and then secure the Safety Pins again.☛ For safety, be sure to secure the PDP Monitor usingthe safety pins. If the safety pins are not used, thePDP Monitor may fall, causing serious injury.